Reciprocating piston engines are by far the most common power source for land and water vehicles, including automobiles, motorcycles, ships and to a lesser extent, locomotives (some are electrical but most use Diesel engines45).Rotary engines of the Wankel design are used in some automobiles, aircraft and motorcycles. Where very high power-to-weight ratios are required, internal combustion engines appear in the form of combustion turbines or Wankel engines.
Wankel engines are fitted to many unmanned aerial vehicles. Big Diesel generator used for backup power Combined cycle power plant ICEs drive some of the large electric generators that power electrical grids.
They are found in the form of combustion turbines in combined cycle power plants with a typical electrical output in the range of 100 MW to 1 GW.
Thus, the efficiency is higher because more energy is extracted from the fuel than what could be extracted by the combustion turbine alone.In combined cycle power plants efficiencies in the range of 50% to 60% are typical. In a smaller scale Diesel generators are used for backup power and for providing electrical power to areas not connected to an electric grid. Small engines (usually 2?stroke gasoline engines) are a common power source for lawnmowers, string trimmers, chain saws, leafblowers, pressure washers, snowmobiles, jet skis, outboard motors, mopeds, and motorcycles.Źródło: https://en.wikipedia.org/wiki/Internal_combustion_engine
Fully autonomous vehicles, also known as driverless cars, already exist in prototype (such as the Google driverless car), and are expected to be commercially available around 2020.According to urban designer and futurist Michael E. Arth, driverless electric vehicles?in conjunction with the increased use of virtual reality for work, travel, and pleasure?could reduce the world's 800 million vehicles to a fraction of that number within a few decades.59 This would be possible if almost all private cars requiring drivers, which are not in use and parked 90% of the time, would be traded for public self-driving taxis that would be in near constant use. This would also allow for getting the appropriate vehicle for the particular need?a bus could come for a group of people, a limousine could come for a special night out, and a Segway could come for a short trip down the street for one person.
Other cycles The very first internal combustion engines did not compress the mixture.
The first part of the piston downstroke drew in a fuel-air mixture, then the inlet valve closed and, in the remainder of the down-stroke, the fuel-air mixture fired.
The exhaust valve opened for the piston upstroke.These attempts at imitating the principle of a steam engine were very inefficient. There are a number of variations of these cycles, most notably the Atkinson and Miller cycles.
A split-cycle engine is really an air compressor on one side with a combustion chamber on the other. Previous split-cycle engines have had two major problems?poor breathing (volumetric efficiency) and low thermal efficiency.However, new designs are being introduced that seek to address these problems. The Scuderi Engine addresses the breathing problem by reducing the clearance between the piston and the cylinder head through various turbo charging techniques.
The Scuderi design requires the use of outwardly opening valves that enable the piston to move very close to the cylinder head without the interference of the valves.Scuderi addresses the low thermal efficiency via firing after top dead centre (ATDC). Firing ATDC can be accomplished by using high-pressure air in the transfer passage to create sonic flow and high turbulence in the power cylinder.Źródło: https://en.wikipedia.org/wiki/Internal_combustion_engine.