Nissan smoking exhaust

Risk when buying used cars

Used cars are mostly purchased vehicles.

Associated with them, however, a certain risk.

Although a large part of the parameters of the vehicle is in the documents attached to the car, there are also such parameters, which often indicate the actual state of the car, but still are often counterfeited by selling such cars.
One of the most important parameters to which we should pay attention when buying a used car is the amount of kilometers driven by it.

Many retailers indulges in illegal manipulations in this area, and then sold their equipment is in much worse condition than shown in the offer.

Ignition

Nissan smoking exhaust
Ignition Internal combustion engines require ignition of the mixture, either by spark ignition (SI) or compression ignition (CI). Before the invention of reliable electrical methods, hot tube and flame methods were used. Experimental engines with laser ignition have been built.15 Spark Ignition Process Bosch Magneto Points and Coil Ignition The spark ignition engine was a refinement of the early engines which used Hot Tube ignition.
When Bosch developed the magneto it became the primary system for producing electricity to energize a spark plug.16 Many small engines still use magneto ignition.
Small engines are started by hand cranking using a recoil starter or hand crank .

Prior to Charles F.

Kettering of Delco's development of the automotive starter all gasoline engined automobiles used a hand crank.17 Larger engines typically power their starting motors and Ignition systems using using the electrical energy stored in a lead?acid battery.
The battery's charged state is maintained by an automotive alternator or (previously) a generator which uses engine power to create electrical energy storage. The battery supplies electrical power for starting when the engine has a starting motor system, and supplies electrical power when the engine is off.

The battery also supplies electrical power during rare run conditions where the alternator cannot maintain more than 13.8 volts (for a common 12V automotive electrical system).

As alternator voltage falls below 13.8 volts, the lead-acid storage battery increasingly picks up electrical load.

During virtually all running conditions, including normal idle conditions, the alternator supplies primary electrical power.Źródło: https://en.wikipedia.org/wiki/Internal_combustion_engine

The first part of the piston downstroke

Other cycles The very first internal combustion engines did not compress the mixture.
The first part of the piston downstroke drew in a fuel-air mixture, then the inlet valve closed and, in the remainder of the down-stroke, the fuel-air mixture fired.
The exhaust valve opened for the piston upstroke.

These attempts at imitating the principle of a steam engine were very inefficient.

There are a number of variations of these cycles, most notably the Atkinson and Miller cycles. The diesel cycle is somewhat different. Split-cycle engines separate the four strokes of intake, compression, combustion and exhaust into two separate but paired cylinders.
The first cylinder is used for intake and compression.
The compressed air is then transferred through a crossover passage from the compression cylinder into the second cylinder, where combustion and exhaust occur. A split-cycle engine is really an air compressor on one side with a combustion chamber on the other. Previous split-cycle engines have had two major problems?poor breathing (volumetric efficiency) and low thermal efficiency.

However, new designs are being introduced that seek to address these problems. The Scuderi Engine addresses the breathing problem by reducing the clearance between the piston and the cylinder head through various turbo charging techniques.

The Scuderi design requires the use of outwardly opening valves that enable the piston to move very close to the cylinder head without the interference of the valves.
Scuderi addresses the low thermal efficiency via firing after top dead centre (ATDC). Firing ATDC can be accomplished by using high-pressure air in the transfer passage to create sonic flow and high turbulence in the power cylinder.Źródło: https://en.wikipedia.org/wiki/Internal_combustion_engine.

Widok do druku:

Nissan smoking exhaust