By 1890 the electric power industry was flourishing, and power companies had built thousands of power systems (both direct and alternating current) in the United States and Europe.
During this time a fierce rivalry known as the "War of Currents" emerged between Thomas Edison and George Westinghouse over which form of transmission (direct or alternating current) was superior.8 In 1891, Westinghouse installed the first major power system that was designed to drive a 100 horsepower (75 kW) synchronous electric motor, not just provide electric lighting, at Telluride, Colorado.9 On the other side of the Atlantic, Mikhail Dolivo-Dobrovolsky built a 20 kV 176 km three-phase transmission line from Lauffen am Neckar to Frankfurt am Main for the Electrical Engineering Exhibition in Frankfurt.10 In 1895, after a protracted decision-making process, the Adams No.
1 generating station at Niagara Falls began transferring three-phase alternating current power to Buffalo at 11 kV.
Following completion of the Niagara Falls project, new power systems increasingly chose alternating current as opposed to direct current for electrical transmission.11 Developments in power systems continued beyond the nineteenth century.In 1936 the first experimental HVDC (high voltage direct current) line using mercury arc valves was built between Schenectady and Mechanicville, New York. HVDC had previously been achieved by series-connected direct current generators and motors (the Thury system) although this suffered from serious reliability issues.12 In 1957 Siemens demonstrated the first solid-state rectifier, but it was not until the early 1970s that solid-state devices became the standard in HVDC.13 In recent times, many important developments have come from extending innovations in the ICT field to the power engineering field.
Special computer programs enable electricians much easier to plan where and how they will run the wire, where will be located branch and so on.
In this way, more and more electricians may remind us of specialists, because the design of electrical networks at the present time is done properly only through the computer.
Well, how can few people know the relevant programming device is often combined with its typical electrical functions.
Therefore, many specialists in the repair of electrical installations must also have knowledge of writing programs that respectively pokierowałyby machine operations.
Nowadays, more and more equipment is armed with complex electrical components, which must be assigned the appropriate settings, so that the whole system to function smoothly..